By 1812Blockhouse
After more than three months of intermittent closure, users of the Richland B&O Trail should be able to resume their journeys through the Lexington-Springmill Road corridor very soon. The Richland County Engineer’s Office has scheduled a tentative Friday, October 23 reopening for the trail crossing, a week ahead of the anticipated opening of the new roundabout at Lexington-Springmill Road and Home Road.
Both dates fall roughly two weeks behind the construction schedule, and officials note that the dates are weather dependent, with separate announcements when the trail and roadway are formally open. The crossing has been closed since July 7 while crews worked on a $2.44 million project to improve safety at one of the county’s more problematic intersections.
A New Crossing for a Popular Trail
The Richland B&O Trail runs an 18.4-mile route through Mansfield, Lexington, Bellville and Butler, making it one of the county’s most heavily used recreational corridors. The trail’s intersection with Lexington-Springmill Road proved a challenge to cyclists, walkers and other trail users who had to cross a busy roadway.
The roundabout project includes relocating the trail crossing north of the new intersection. Rather than requiring users to cross multiple lanes of traffic at once, a refigured crossing includes a refuge area within a raised median. That allows pedestrians and bicyclists to cross one direction of traffic at a time, pausing in the median before proceeding across the opposite lanes.
The design also includes street lighting, pavement markings and signs to help make trail users more visible to approaching motorists.
Vehicles traveling through the roundabout are expected to travel at approximately 25 mph, considerably slower than traffic approaching the former intersection. While the improvements fall short of removing all the risk of passing through a public roadway, county engineers expect that the lower speeds and refigured crossing will provide a safer environment.
The closure has interrupted through travel on the trail from Mansfield to Lexington. County officials said allowing trail traffic through the construction zone would create unacceptable safety concerns; no detour was officially posted. If the October 23 target is met, that will be a week ahead of the time for motorists to begin using the new roundabout.
A Troubled Intersection Gets a New Design
The project was born of a 2021 traffic safety study that surveyed approximately three miles of Lexington-Springmill Road between Cockley Road and Marion Avenue Road, looking for the corridor’s highest priority for safety improvements.
The Home Road intersection was identified as such.
Between 2017 and 2019, the intersection experienced 16 reported crashes, averaging approximately 5.3 annually; nearly one-third were reported to have involved injuries.
Ten of those crashes involved motorists entering Lexington-Springmill Road from Home Road who failed to yield to approaching traffic, and two involved southbound vehicles hitting vehicles waiting to turn left onto Home Road.
County engineers attributed many of the problems to traffic speeds, inadequate opportunities to enter the roadway and delays experienced by motorists waiting to proceed.
The new roundabout is expected to alleviate the problems by slowing approaching vehicles and replacing the traditional intersection with a circular traffic pattern in which entering motorists yield to those already going around the central island. Engineers have projected that the improvement could reduce crashes by more than half, reducing the likelihood of serious injuries, as well.
Why the County Chose a Roundabout
The decision to install a roundabout was the result of an evaluation of alternatives and an opportunity for public comment. During the county’s 2024 public involvement process, residents submitted 33 comments that expressed a range of opinions. Some supported the safety improvements, but others questioned whether a roundabout was appropriate for the location.
Concerns included the ability of large trucks and agricultural equipment to navigate the intersection, visibility and winter driving conditions, and the inconvenience of the construction. A conventional traffic signal and additional turn lanes were also considered.
According to the county’s responses to public comments, the alternative offered similar safety benefits at a similar estimated construction cost; engineers ultimately favored the roundabout because of its smaller construction footprint and the fact that it would slow traffic throughout the day instead of only as motorists encountered a red signal. The design includes a mountable paved apron around the central island, providing additional maneuvering space for semitrailers and agricultural equipment.
Construction Moves Toward Completion
Work began June 15 under a contract with Adena Corporation for $2,440,932.15 for the roundabout itself. Beyond construction of the roundabout, the project includes two bridges, drainage improvements and a relocated B&O Trail crossing.
The work has resulted in the closure of Lexington-Springmill Road between Cook Road and Marion Avenue Road, plus Home Road between Lexington-Springmill Road and Marion Avenue Road. Motorists were directed to a detour using Lexington Avenue (U.S. 42), Trimble Road and Park Avenue West (State Route 430).
The tentative opening of the roadway on October 30 will restore a major north-south connection that has been unavailable throughout much of the summer and early fall. For the county, the project represents a substantial investment in reducing crashes and improving the movement of vehicles through an important travel corridor. For trail users, however, the most eagerly awaited date falls in October 23. After months of restricted access, the reopening would connect a popular section of the Richland B&O Trail and include a new crossing that considers their safety.
The Richland County Engineer’s Office cautions that neither reopening is a given; weather and construction work could change the schedule, and officials will issue separate notices when each facility is ready to open to the public.
Source, Photo: Richland County Engineer